Operating Instructions; Run Pattern (Chase Mode) - Chauvet TFX-16CON Technical Reference And User's Manual

Operating Instructions

Run Pattern (chase mode)

The user can select from four chase modes also referred to as PATTERN modes; AUTO, MANUAL
STEP, AUDIO, and TAP SYNC. There are different levels of interactivity within each mode and they are
charted in the table below. Run pattern modes provide the controller the primary means for show playback.
Note! The status of a mode will be indicated in the LCD display by a single dot adjacent to the appropriate label.
Select desired chase mode by pressing the buttons
indicated.
Rotate the Level knob full right, and lower the
Master fader to the bottom to ensure proper
Chase/Pattern mode operation.
Press the (M) PATTERN (N) to select the
desired pattern from the 30 pre-programmed in
memory (31-60) or from the user programmable
area (1-30).
Press the (N) STEP (M) arrow buttons to select
individual steps preferably in MANUAL STEP
mode.
Rotate the Speed knob to change the chase speed
from super fast 10 steps per second to a slow 1
step per every 5 minutes. Alternately you can
control a fade time by selecting Shift +
Fade/Time Set Up button, then rotating the
Speed knob which is also the Fade Time knob.
Rotate Audio knob to adjust sensitivity to music
for Audio mode operation.
Tap Sync mode will sample the time in 2
concurrent taps or presses of this button and run
it accordingly.
TFX-16CON Manual Version 1.20
PATTERN MODES
AUTO AUDIO
Shift +
(Audio/Chase)
(Audio/Chase)
Reference # 24
Reference # 24
MANUAL
TAP SYNC
STEP
Shift +
(Manual
(Manual
Step/Tap Sync)
Step/Tap Sync)
Reference # 25
Reference # 25
11