Horizon Fitness RCT7.6 Assembly & User's Manual page 8

PR E- AS S EM BLY
Disassemble box and remove the cardboard packaging that is not beneath the treadmill. Do not attempt to
lift the treadmill at this time. Remove plastic wrap from console masts.
*NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of
hardware. Any grease, such as lithium bike grease is recommended.
A S SE MB LY S T E P 1
HARDWARE BAG 1 CONTENTS :
LEAD WIRE

FLAT WASHER (B)
Qty: 4
RIGHT CONSOLE MAST CONSOLE CABLE
Open HARDWARE BAG 1.
A)
BOLT (A)
65 mm
Pull LEAD WIRE through RIGHT
B)
Qty: 4
CONSOLE MAST to drag upward.
Place RIGHT CONSOLE MAST
C)
into upright position using 2
BOLTS (A) and 2 FLAT WASHERS
(B), then tighten. Be sure to
hold the CONSOLE MAST firmly,
as it will not stay in the upright
position on its own.
*NOTE: Do not pinch CONSOLE
CABLE when placing the mast
onto the main frame.
Repeat on the left side.
D)
*NOTE: There is no wire in the
LEFT CONSOLE MAST.
CONSOLE MAST
FLAT WASHERS (B)
BOLT (A)