Sas Or Sata Hard Drive Option - HP ProLiant ML350 User Manual

Install the DIMM.
8.
Install a fan, if removed.
9.
Install the DIMM baffle.
10.
Install the large redundant fan air baffle, if removed.
11.
Install the access panel (on page 27).
12.
Do one of the following:
13.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 24).
14.
After installing DIMMs, configure the AMP mode in RBSU

SAS or SATA hard drive option

CAUTION:
expansion slot covers, hard drives, or blanks installed.
IMPORTANT:
the x3 part of the x3/x1 cable to the SAS hard drive backplane connector that corresponds to
hard drive slots 1 to 4. In this setup, hard drive slot 1 is not available, but because hard drive slots
2 to 4 are connected, one continuous volume can be created. All drive slots are available in LFF
systems.
For proper cooling, do not operate the server without the access panel, baffles,
When installing a x3/x1 SAS cable in an SFF system, HP recommends connecting
("HP ROM-Based Setup
Hardware options installation 52
Utility" on page 92).