Automatically
pausing and
resuming the
scanner
Power Saver mode
Resuming from Power
Saver or Low-Power mode
A-61670 December 2010
During scanning the scanner monitors its own internal image buffer memory. In
order to prevent overwriting images before the host computer can retrieve
them, the scanner will automatically pause the feeder while waiting for the
scanning application to read existing images.
The scanner resumes scanning by automatically restarting the feeder once the
scanning application has caught up.
The Kodak i5000 Series Scanners are configured from the factory to go into
Power Saver mode after 15 minutes of inactivity. This setting can be changed
by your scanning application. If Power Saver is enabled, the scanner will begin
a one-minute count-down prior to entering Power Saver mode.
Once in Power Saver mode, after one hour of inactivity, the scanner will go into
low-power mode. When the scanner is in Power Saver mode, the yellow LED
will be flashing and the touchscreen will be blank. When the scanner goes into
Low-Power mode, the yellow LED will be solid.
NOTE: If you do not want to go into Power Saver mode, touch Cancel.
• If there is paper in the input elevator, take the paper out and put it back in.
• If no paper is in the input elevator, put paper in the input elevator.
• Touch the Start/Resume or Power button.
The initializing screen will appear on the touchscreen.
3-23