Lowering The Elevator; Viewing The Operator Log; Troubleshooting - Kodak i5000 series User Manual

Lowering the elevator

Viewing the Operator Log

3-8
If the User counter is set to On (see "User counter" later in this chapter for
more information) the Show User Counter/Show Document Counter and
Reset User Counter will also be displayed on the Idle screen. These options
allow you to select which counter value is being displayed as well as reset the
value of the User counter (the Document counter must be reset by the
scanning application).
• Clear Path — clears the scanner transport of any documents.
• Diagnostics — allows you to run a Print Test, run a scanner Self Test, put
the scanner in Count Only mode, perform a UDDS (ultrasonic) calibration
and perform a Touchscreen calibration.
Use this option whenever you need to make additional room in the input
elevator tray for adding documents to the stack. The input elevator will
descend to the lowest position (750-sheet) when you touch Lower Elevator.
When you touch Operator Log, the Operator Log screen will be displayed. This
screen provides the time, message code and a message description.
The messages that are displayed in the log are only those messages that have
occurred since the scanner was powered on. When you turn the power off or
the scanner goes into Standby or Low-Power mode, the Operator Log on the
Operator Control Panel touchscreen will be cleared.
To view messages which have been cleared from the Operator Control Panel
touchscreen, see Chapter 6, Troubleshooting.
• After viewing the operator log, touch Close to return to the Idle screen.
A-61670 December 2010