Universal Plug And Play - NETGEAR JWNR2010v5 N300 User Manual

8. Type the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255.
9. Type the gateway IP address, which must be a router on the same LAN segment as the
JWNR2010v5 N300 Wireless Router.
10. Type a number from 1 through 15 as the metric value.
This value represents the number of routers between your network and the destination.
Usually, a setting of 2 or 3 works, but if this link is a direct connection, set it to 1.
11. Click the Apply button.
The route is added to the table on the Static Routes screen.
To edit or delete a static route:

1. Log in to the router.
For more information, see
2. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes screen displays.
3. In the table, select the radio button next to the route that you want to edit or delete.
4. To edit the route, click the Edit button.
The Static Routes screen adjusts.
a. Edit the route information.
b. Click the Apply button.
5. To delete the route, click the Delete button.
The route is removed from the table.

Universal Plug and Play

Universal Plug and Play (UPnP) helps devices, such as Internet appliances and computers,
to access the network and connect to other devices as needed. UPnP devices can
automatically discover the services from other registered UPnP devices on the network.
Note: If you use applications such as multiplayer gaming, peer-to-peer
connections, or real-time communications such as instant messaging
or remote assistance, enable UPnP.
To configure Universal Plug and Play:

1. Log in to the router.
For more information, see
2. Select ADVANCED > Advanced Setup > UPnP.
JWNR2010v5 N300 Wireless Router
Log In to Your Router After Installation
Log In to Your Router After Installation
Advanced Settings
67
on page 18.
on page 18.