Lan Setup - NETGEAR JWNR2010v5 N300 User Manual

LAN Setup

You can configure LAN IP services such as Dynamic Host Configuration Protocol (DHCP)
and Routing Information Protocol (RIP).
The router is shipped preconfigured to use private IP addresses on the LAN side and to
function as a DHCP server. The router's default LAN IP configuration includes the following
settings:
• LAN IP address. 192.168.1.1
• Subnet mask. 255.255.255.0
These addresses are part of the designated private address range for use in private networks
and are suitable for most applications. If your network requires the use of a different IP
addressing scheme, change the settings in the LAN Setup screen.
Note: If you change the LAN IP address of the router while connected
through the browser, you are disconnected. If this situation occurs,
you must open a new connection to the new IP address and log in
again.
To change the LAN settings:

1. Log in to the router.
For more information, see
2. Select ADVANCED > Setup > LAN Setup.
JWNR2010v5 N300 Wireless Router
Log In to Your Router After Installation
genie ADVANCED Home
46
on page 18.