Initial Setup - Invacare xlt User Manual

5 Initial Setup

WARNING - RISK OF INJURY OR DAMAGE
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or
damage may occur.
DO NOT operate the handcycle if the hand crank obstructs your view. If the hand crank obstructs your view, adjust the hand
crank height before using the handcycle - otherwise injury or damage may occur.
 Required tools:
• Adjustable Wrench (10-12 inches)
• 5, 6, 8, 9 and 32 mm Wrenches
3
• / -inch Allen Wrench
16
• ¼-inch Allen Wrench
• ½-inch Box Wrench
• ½-inch Socket Wrench
1
• / -inch Allen Wrench
8
• Medium Flat Screwdriver
• Medium Phillips™ Screwdriver
1. Install the rear wheels. Refer to Installing/Adjusting the Rear Wheel and Quick-Release Axles on page 50.
2. Adjust footrest. Refer to Adjusting the Footrest on page 43.
 Excelerator Series - Foot should be flat on the footrest with the knees in a 90° angle.
XLT Series - The sole of the foot should rest against the inside edge of the footrest when the knee is slightly bent.
3. Adjust hand crank assembly if the user is unable to see over the hand crank or if knees obstruct hand crank rotation. Refer to Adjusting Hand Crank
Height on page 45.
Part No 1171891
31
Invacare® Top End® Recreation Handcycles
5 INITIAL SETUP