Adjusting Toe In/Toe Out - Invacare xlt User Manual

8 WHEELS
8.3

Adjusting Toe In/Toe Out

1. Loosen, but do not remove the socket screws and clamps that
secure camber inserts to the camber bar.
2. Slowly rotate the camber insert until the rear wheels are
approximately in a straight line.
3. Securely tighten the socket screws and clamps that secure the
camber inserts to the camber bar.
4. Measure the distance between the center lines at the rear and front
of the rear wheels at approximately 12 inches from the
ground/floor. Refer to Determining Toe In/Toe Out on page 51.
5. Repeat STEPS 1-4 until the toe in/toe out measurement is less than
1/8-inch (for maximum rollability).
Invacare® Top End® Recreation Handcycles
Camber
Insert
52
Clamp
Camber Bar
Socket Screw
Part No 1171891