Section 3 - Initial Setup; Initial Setup - Invacare Excelerator Owner's Operator And Maintenance Manual

SECTION 3
Section 3 - Initial Setup - includes the following:

Initial Setup

After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may result.
DO NOT operate the handcycle if the hand crank obstructs your view. If the
hand crank obstructs your view, adjust the hand crank height BEFORE using the
handcycle - otherwise injury or damage may occur.
INITIAL SETUP (FIGURE 1)
NOTE: Invacare recommends that the following procedure be performed by a qualified technician.
Tools required:
Adjustable wrench (10 to 12-inches)
1/2-inch box wrench
6, 8 and 9mm wrench
1/8-inch allen wrench
Medium phillips screwdriver
Medium flat screwdriver
1. Install and adjust rear wheels (SECTION 6). Ensure quick release axles secure
wheels to the handcycle.
2. Adjust footrest (SECTION 5) so that knees are at a 90° angle.
3. Adjust hand crank assembly (SECTION 5) if unable to see over hand crank or if
knees obstruct hand crank rotation.
4. Adjust chain length (SECTION 7) if crank has been adjusted.
5. Ensure parking brake (SECTION 7) functions properly. Check tension and adjust
parking brake cable (SECTION 7) if necessary.
6. Pedal backwards to ensure reversing drum brake works properly.
7. Adjust back height (SECTION 5).
8. Adjust seat position/upholstery (SECTIONS 5 and 7).
9. Check that all hardware is tight.
Excelerator™Series
WARNING
18
INITIAL SETUP
Part No. 1056188