D-Link DES-3010F Manual page 55

Auth-Protocol
Priv-Protocol
To return to the SNMP User Table, click the
To add a new entry to the SNMP User Table Configuration, click on the Add button on the SNMP User Table page.
This will open the SNMP User Table Configuration page, as shown below.
The following parameters can set:
Parameter
User Name
Group Name
SNMP Encryption
Auth-Protocol
Priv-Protocol
To implement changes made, click Apply. To return to the SNMP User Table, click the
Entries link.
DES-3010F/G / DES-3018 / DES-3026 Fast Ethernet Switch Manual
None - Indicates that no authorization protocol is in use.
MD5 - Indicates that the HMAC-MD5-96 authentication level will be used.
SHA - Indicates that the HMAC-SHA authentication protocol will be used.
None - Indicates that no authorization protocol is in use.
DES - Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-
56) standard.
Show All SNMP User Table Entries
Figure 6- 17. SNMP User Table Configuration window
Description
Enter an alphanumeric string of up to 32 characters. This is used to identify the SNMP
user.
This name is used to specify the SNMP group created can request SNMP messages.
Click the encrypted check box to enable encryption for the SNMP protocol. This
feature is for users utilizing the SNMP V3 version. The user may configure the
encryption in the following two fields.
MD5 - Specifies that the HMAC-MD5-96 authentication level will be used. This field is
only operable when V3 is selected in the SNMP Version field and the Encryption
field has been checked. This field will require the user to enter a password.
SHA - Specifies that the HMAC-SHA authentication protocol will be used. This field is
only operable when V3 is selected in the SNMP Version field and the Encryption
field has been checked. This field will require the user to enter a password.
None - Specifies that no authorization protocol is in use.
DES - Specifies that DES 56-bit encryption is in use, based on the CBC-DES (DES-
56) standard. This field is only operable when V3 is selected in the SNMP Version
field and the Encryption field has been checked. This field will require the user to
enter a password between 8 and 16 alphanumeric characters.
link.
54
Show All SNMP User Table