Reauthenticate Port(S) For Port Based 802.1X - D-Link DES-3010F Manual

Reauthenticate Port(s) for Port Based 802.1x

This window allows you to reauthenticate a port or group of ports by choosing a port or group of ports by using the pull
down menus From and To and clicking Apply. The Reauthenticate Port Table displays the current status of the
reauthenticated port(s) once you have clicked Apply.
Click Security > 802.1X > Reauthenticate Port(s) to view the following window:
Figure 9- 17. Reauthenticate Port and Reauthenticate Port Table window
This window displays the following information:
Parameter
Port
MAC Address
Auth PAE State
BackendState
Open Dir
PortStatus
DES-3010F/G / DES-3018 / DES-3026 Fast Ethernet Switch Manual
Description
The port number of the reauthenticated port.
Displays the physical address of the Switch where the port resides.
The Authenticator State will display one of the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth or ForceUnauth.
The Backend State will display one of the following: Request, Response, Success, Fail,
Timeout, Idle or Initialize.
The Operational Controlled Directions are both and in.
The status of the controlled port can be Authorized or Unauthorized.
NOTE: The user must first globally enable 802.1X in the DES-3018 Web
Management Tool window before reauthenticating ports. Information in
the Reauthenticate Ports Table cannot be viewed before enabling
802.1X.
NOTE: The uplink module ports (DES-3010F/G ports 9-10, DES-3018
ports 17-18, DES-3026 ports 25-26) do not support the 802.1X function.
104