D-Link DES-3010F Manual page 113

The following fields may be set or viewed:
Parameter
Time Interval [1s ]
Record Number [200]
Bytes
Packets
Unicast
Multicast
Broadcast
Show/Hide
Clear
View Table
View Line Chart
DES-3010F/G / DES-3018 / DES-3026 Fast Ethernet Switch Manual
Figure 10- 4. Rx Packets Analysis Table
Description
Select the desired setting between 1s and 60s, where "s" stands for seconds. The
default value is one second.
Select number of times the Switch will be polled between 20 and 200. The default
value is 200.
Counts the number of bytes received on the port.
Counts the number of packets received on the port.
Counts the total number of good packets that were received by a unicast address.
Counts the total number of good packets that were received by a multicast address.
Counts the total number of good packets that were received by a broadcast address.
Check whether to display Bytes and Packets.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Clicking this button instructs the Switch to display a line graph rather than a table.
112