D-Link DES-3010F Manual page 115

Figure 10- 5. Rx Packets Analysis window (table for Unicast, Multicast, and Broadcast Packets)
The following fields may be set or viewed:
Parameter
Time Interval [1s]
Record Number [200]
Unicast
Multicast
Broadcast
Show/Hide
Clear
View Table
View Line Chart
DES-3010F/G / DES-3018 / DES-3026 Fast Ethernet Switch Manual
Description
Select the desired setting between 1s and 60s, where "s" stands for seconds. The
default value is one second.
Select number of times the Switch will be polled between 20 and 200. The default
value is 200.
Counts the total number of good packets that were received by a unicast address.
Counts the total number of good packets that were received by a multicast address.
Counts the total number of good packets that were received by a broadcast address.
Check whether or not to display Multicast, Broadcast, and Unicast Packets.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Clicking this button instructs the Switch to display a line graph rather than a table.
114