Lcd Message Delivery; Assist Button Message Delivery - Comdial DSU II User Manual

Nonverbal Messaging

LCD Message Delivery

You can set system-supplied messages to be received and displayed by a calling
LCD speakerphone.
To turn message on,
1. PRESS INTERCOM.
2. DIAL
3. DIAL the desired number from your message list. The default
messages of "Back At" and "Call" may be used:
• For default message 1, which is "Back At," dial time in
• For default message 2, which is "Call," dial the telephone
4. PRESS SPEAKER to end message. Intercom light flashes steadily.
To turn off message and your intercom light,
1. PRESS INTERCOM.
2. DIAL

Assist Button Message Delivery

If you have preprogrammed an ASSIST button on your telephone, you can use it to
send an LCD message to your supervisor, asking for assistance while you are on a
call. See page 54 for instructions on programming an ASSIST button.
To send a message for assistance,
1. PRESS ASSIST button that you have programmed.
2. PRESS DSS/BLF of the telephone user you need help from. (This is
not necessary when the desired extension number was stored along
with the ASSIST button programming.)
3. If the assisting telephone is idle, a ring burst sounds and a message
appears in its display. If it is busy, the message appears when it
becomes idle.
44
.
twelve-hour format using the # as a colon.
number of where you will be.
.
LCD Speakerphone Station User's Guide
GCA70-281