Dell PowerConnect W-AirWave 7.6 User Manual page 87

Table 54:
Groups > SSIDs Fields and Descriptions
Field
SSID
VLAN ID
Name
Encryption Mode
First or Second Radio
Enabled
First or Second Radio
Primary
Native VLAN
3. Select Add to create a new SSID or VLAN, or select the pencil icon next to an existing SSID/VLAN to edit that
existing SSID or VLAN. The Add SSID/VLAN configuration page appears as illustrated in
explained in Table
Figure 43:
Groups > SSIDs > Add SSID/VLAN Page Illustration
4. Locate the SSID/VLAN section on the Groups > SSIDs configuration page and adjust these settings as
required. This section encompasses the basic VLAN configuration.
values. Note that the displayed settings can vary.
Table 55:
Groups > SSIDs > SSID/VLAN Section Fields and Default Values
Setting
Specify Interface Name
Dell PowerConnect W-AirWave 7.6 | User Guide
Description
Displays the SSID associated with the VLAN.
Identifies the number of the primary VLAN SSID on which encrypted or unencrypted packets
can pass between the AP and the switch.
Displays the name of the VLAN.
Displays the encryption on the VLAN.
Enables the VLAN, SSID and Encryption Mode on the radio control.
Specifies which VLAN to be used as the primary VLAN. A primary VLAN is required.
NOTE: If you create an open network (see the Create Closed Network setting below) in which
the APs broadcast an SSID, the primary SSID is broadcast.
Sets this VLAN to be the native VLAN. Native VLANs are untagged and typically used for
management traffic only. AirWave requires a Native VLAN to be set. For AP types do not
require a native VLAN, create a dummy VLAN, disable it on both radio controls, and ensure that
it has the highest VLAN ID.
55.
Default Description
Enables or disables an interface name for the VLAN interface. Selecting No
Yes
for this option displays the Enable VLAN Tagging and VLAN ID options.
Figure 43
Table 55 describes the settings and default
Configuring and Using Device Groups | 75
and