Dell PowerConnect W-AirWave 7.6 User Manual page 161

level override for its referenced Spectrum profile, as illustrated in
APs managed by this controller.
Figure 111:
Override Section of a Supported Controller's Manage Page
Perform these steps to override individual profile settings for an Dell PowerConnect W-Seriescontroller that is part
of a spectrum-mode Dell PowerConnect W AP group:
1. Select a Spectrum-supported Dell PowerConnect W-Seriescontroller that is referencing a Spectrum profile, and go
to its APs/Devices > Manage page. Set it to Manage Read/Write mode.
2. Under the Dell PowerConnect WOverrides section, select Add New Dell PowerConnect WController
Override.
3. In the Profile drop-down menu, select the Spectrum Profile type.
4. In the Profile Instance drop-down menu, select the instance of the Spectrum profile used by the controller.
5. In the Field drop-down menu, select the setting you would like to change (such as an Age-Out setting or a
Spectrum Band), and enter the overriding value below it.
6. Select Add to save your changes.
7. To create additional overrides for this controller, select Add New Dell PowerConnect W Controller Override
again.
8. When you have finished, select Save and Apply.
You can also use the above procedure to turn on Spectrum mode for radio profiles on one particular controller, or use
the overrides to point your radio profile to a non-default Spectrum profile for just this controller.
Dell PowerConnect W-AirWave 7.6 | User Guide
Figure 111. This will affect all Spectrum-supported
Discovering, Adding, and Managing Devices | 149