Dell PowerConnect W-AirWave 7.6 User Manual page 54

3. Locate the SNMPv3 Informs section. Select the Add button to reveal configuration options. AirWave users will
need to configure all v3 users that are configured on the controller. The SNMP Inform receiver in the AirWave
will be restarted when users are changed or added to the controller.
Username - Username of the SNMP v3 user as configured on the controller.
l
Auth Protocol - Can be MD5 or SHA. The default setting is SHA.
l
Auth and Priv Protocol Passphrases - Enter the authentication and privilege protocol passphrases for the user
l
as configured on the controller.
Priv Protocol - Can be DES or AES. The default setting is DES..
l
NOTE: This form allows you to edit existing SNMPv3 users by selecting the pencil icon next to the desired user. It also allows you to
remove existing users by selecting the user's checkbox and then clicking Delete.
4. Locate the Telnet/SSH Settings section, and complete or adjust the default value for the field.
the setting and default value.
Table 27:
Device Setup > Communication > Telnet/SSH Settings Fields and Default Values
Setting
Telnet/SSH Timeout
(3-120 sec)
5. Locate the HTTP Discovery Settings section and adjust the default value.
default value.
Table 28:
Device Setup > Communication > HTTP Discovery Settings Fields and Default Values
Setting
HTTP Timeout
(3-120 sec)
6. Locate the ICMP Settings section and adjust the default value as required.
default value.
Table 29:
Device Setup > Communication > ICMP Settings Fields and Default Values
Setting
Attempt to
ping devices
that were
unreachable
via SNMP
7. Locate the Symbol 4131 and Cisco Aironet IOS SNMP Initialization area. Select one of the options listed.
Table 30 describes the settings and default values
42 | Configuring AirWave
Default Description
10 Sets the timeout period in seconds used when performing Telnet and SSH commands.
Default Description
5 Sets the timeout period in seconds used when running an HTTP discovery scan.
Default Description
When Yes is selected, AirWave attempts to ping the AP device.
l
Select No if performance is affected in negative fashion by this function. If a large
l
number of APs are unreachable by ICMP, likely to occur where there is in excess of 100
Yes
APs, the timeouts start to impede network performance.
NOTE: If ICMP is disabled on the network, select No to avoid the performance penalty
caused by numerous ping requests.
Table 27
Table 28 shows the setting and
Table 29 shows the setting and
Dell PowerConnect W-AirWave 7.6 | User Guide
shows