Dell PowerConnect W-AirWave 7.6 User Manual page 205

Figure 131:
System > Triggers > Add Trigger Type Drop Down Menu
The Add Trigger page changes depending on the trigger type that you select. In many cases, you must configure
at least one Condition setting. Conditions, settings and default values vary according to trigger type. Triggers
with conditions can be configured to fire if any criteria match as well as if all criteria match.
Some trigger types share common settings, such as Duration (which can be expressed in hours, minutes,
n
seconds, or a combination of these) and Severity (from Normal to Critical).
After you select Save, the trigger appears on your next viewing of the System > Triggers page with all other
n
active triggers.
You can edit or delete any trigger as desired from the System > Triggers page.
n
To edit an existing trigger, select the pencil icon next to the respective trigger and edit settings in the
n
Trigger Detail page described in
To delete a trigger, check the box next to the trigger to remove, and select Delete.
n
3. Configure the Trigger Restrictions and Alert Notifications. This configuration is consistent regardless of the
trigger type to be defined.
a. The Trigger Restrictions settings establishes how widely or how narrowly the trigger applies. Define the
folder, subfolder, and Group covered by this trigger.
Table 105:
System > Trigger Restrictions Fields and Default Values
Notification Option
Folder
Include Subfolders
Group
Dell PowerConnect W-AirWave 7.6 | User Guide
Table 106.
Description
Sets the trigger to apply only to APs/Devices in the specified folder or subfolders depending on the
Include Subfolders option.
NOTE: If the trigger is restricted by folder and group, it only applies to the intersection of the
two—it only applies to APs in the group and in the folder.
Sets the trigger to apply to all devices in the specified folder and all of the devices in folders
under the specified folder.
Sets the trigger to apply only to APs/Devices in the specified group.
NOTE: If the trigger is restricted by folder and group, it only applies to the intersection of the
two—it only applies to APs in the group and in the folder.
Table 105 describes the options for trigger restrictions.
Performing Daily Administration in AirWave | 193