Dell PowerConnect W-AirWave 7.6 User Manual page 79

Setting
Bridge
Maximum Age
Bridge Hello
Time
Bridge Forward
Delay
10. To configure Network Time Protocol (NTP) settings locate the NTP section and adjust these settings as
required. Table 45
Table 45:
NTP Fields and Default Values
Setting
NTP Server #1,
2,3
UTC Time Zone
Daylight Saving
Time
11. To configure settings specific to Cisco IOS/Catalyst, locate the Cisco IOS/Catalyst section and adjust these
settings as required.
Table 46:
Cisco IOS/Catalyst Fields and Default Values
Setting
SNMP Version
Cisco IOS CLI
Communication
Cisco IOS Config File
Communication
12. To configure settings specific to Cisco WLC, locate the Cisco WLC section and adjust these settings as
required. Table 47
Table 47:
Cisco WLC Fields and Default Values
Setting
SNMP Version
CLI Communication
Dell PowerConnect W-AirWave 7.6 | User Guide
Default Description
Sets the maximum time, in seconds, that the device stores protocol information. The
20
supported range is from 6 to 40.
2 Sets the time, in seconds, between Hello message broadcasts.
Sets the time, in seconds, that the port spends in listening and learning mode if the
15
spanning tree has changed.
describes the settings and default values.
Default Description
None Sets the IP address of the NTP servers to be configured on the AP.
Sets the hour offset from UTC time to local time for the AP. Times displayed in AirWave
0
graphs and logs use the time set on the AirWave server.
Enables or disables the advanced daylight saving time settings in the Proxim section of the
No
Groups > Basic configuration page.
Table 46 describes the settings and default values.
Default Description
2c The version of SNMP used by AirWave to communicate to the AP.
The protocol AirWave uses to communicate with Cisco IOS devices. Selecting SSH
Telnet uses the secure shell for command line page (CLI) communication and displays an
SSH Version option. Selecting Telnet sends the data in clear text via Telnet.
The protocol AirWave uses to communicate with Cisco IOS devices. Selecting SCP
uses the secure copy protocol for file transfers and displays an SCP Version option.
TFTP
Selecting TFTP will use the insecure trivial file transfer protocol. The SCP login
and password should be entered in the Telnet username and password fields.
describes the settings and default values.
Default Description
2c Sets the version of SNMP used by AirWave to communicate to WLC controllers.
Sets the protocol AirWave uses to communicate with Cisco IOS devices. Selecting
SSH SSH uses the secure shell for command line page (CLI) communication. Selecting
Telnet sends the data in clear text via Telnet.
Configuring and Using Device Groups | 67