Debug Platform Configuration - Cisco Catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug platform configuration

Use the debug platform configuration privileged EXEC command to enable debugging of
configuration file activity across the stack. Use the no form of this command to disable debugging.
Syntax Description
all
reception
transmission
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug platform configuration command is the same as the no debug platform configuration
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
78-16181-03
debug platform configuration {all | reception | transmission}
no debug platform configuration {all | reception | transmission}
Display debug messages for all configuration file transmission and reception events
throughout the stack.
Display debug messages for configuration file reception from other stack members.
Display debug messages for configuration file transmission to other stack members.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
debug platform configuration
Catalyst 3750 Switch Command Reference
B-29