Debug Pagp - Cisco Catalyst 3750 Command Reference Manual

debug pagp

debug pagp
Use the debug pagp privileged EXEC command to enable debugging of Port Aggregation Protocol
(PAgP) activity. Use the no form of this command to disable debugging.
Syntax Description
all
event
fsm
misc
packet
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines
The undebug pagp command is the same as the no debug pagp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show pagp
Catalyst 3750 Switch Command Reference
B-26
debug pagp [all | event | fsm | misc | packet]
no debug pagp [all | event | fsm | misc | packet]
(Optional) Display all PAgP debug messages.
(Optional) Display PAgP event debug messages.
(Optional) Display PAgP finite state-machine debug messages.
(Optional) Display miscellaneous PAgP debug messages.
(Optional) Display PAgP packet debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Displays PAgP channel-group information.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-03