Show Idprom - Cisco Catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

show idprom

Use the show idprom user EXEC command to display the IDPROM information for the specified
interface.
Syntax Description interface interface-id
detail
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History Release
12.2(20)SE1
Usage Guidelines
This command applies only to 10-Gigabit Ethernet interfaces.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show idprom interface tengigabitethernet1/0/1 command for
the 10-Gigabit Ethernet interface. It shows the XENPAK module serial EEPROM contents.
For information about the EEPROM map and the field descriptions for the display, see the XENPAK
multisource agreement (MSA) at these sites:
http://www.xenpak.org/MSA/XENPAK_MSA_R2.1.pdf
http://www.xenpak.org/MSA/XENPAK_MSA_R3.0.pdf
To determine which version of the XENPAK documentation to read, see the XENPAK MSA Version
supported field in the display. Version 2.1 is 15 hexadecimal, and Version 3.0 is 1E hexadecimal (not
shown in the example).
Switch# show idprom interface tengigabitethernet1/0/1
TenGigabitEthernet1/0/1 (gpn:472, port-number:1)
-----------------------------------------------------------
XENPAK Serial EEPROM Contents:
Non-Volatile Register (NVR) Fields
XENPAK MSA Version supported
NVR Size in bytes
Number of bytes used
Basic Field Address
78-16181-03
show idprom {interface interface-id} [detail] [ | {begin | exclude | include} expression]
Display the IDPROM information for the specified 10-Gigabit Ethernet
interface.
(Optional) Display detailed hexidecimal IDPROM information.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
:0x15
:0x100
:0xD0
:0xB
Catalyst 3750 Switch Command Reference
show idprom
2-355