Cisco Catalyst 3750 Command Reference Manual page 386

show interfaces
transceiver
[calibration |
detail |
properties]
trunk
| begin
| exclude
| include
expression
1. Coarse Wave Division Multiplexer
2. Dense Wave Division Multiplexer
Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
Note
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
12.1(14)EA1
12.2(20)SE
Usage Guidelines
The show interfaces capabilities command with different keywords has these results:
•
•
•
•
Catalyst 3750 Switch Command Reference
2-358
(Optional) Display the physical properties of a CWDM
form-factor (SFP) module interface. The keywords have these meanings:
calibration—(Optional) Display temperature, voltage, or amount of current
•
on the interface.
detail—(Optional) Display calibration properties, including high and low
•
numbers and any alarm information.
properties—(Optional) Display speed, duplex, and inline power settings on
•
an interface.
Display interface trunk information. If you do not specify an interface, only
information for active trunking ports is displayed.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Support for the capabilities keyword was added.
The private-vlan mapping, backup, transceiver calibration, detail, and
properties, keywords were added.
Use the show interface capabilities module number command to display the capabilities of all
interfaces on that switch in the stack. If there is no switch with that module number in the stack,
there is no output.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
Use the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces in the stack.
Use the show interface switchport module number command to display the switch port
characteristics of all interfaces on that switch in the stack. If there is no switch with that module
number in the stack, there is no output.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
1
or DWDM
2
small
78-16181-03