Brother HL-5240 Service Manual page 238

CHAPTER 5 DISASSEMBLY AND RE-ASSEMBLY
(5) Remove the bind B M4x12 Taptite screw, and then remove the SW holder ASSY.
(6) Float the Fan motor 60 unit LV from the Frame R.
NOTE:
Do not remove the Fan motor 60 unit LV at the above step.
SW holder ASSY
(7) Remove the Inlet harness ASSY from the SW holder.
(8) Press the Hooks on both sides of the Power supply switch, pull out the Power supply
switch to the direction of 8a and pull the wire out of the groove on the SW holder.
Inlet harness ASSY
Assembling Note:
When assembling the power supply switch onto the SW holder, give attention to the direction
of the switch.
5
Fig. 5-89
7
8b
Power supply switch
Hook
Fig. 5-90
5-58
6
Fan motor 60 unit LV
Taptite, bind B M4x12
SW holder
8a
Hook
Frame R
<Right side>
Confidential