Component Breakdown: Steering Unit - Cub Cadet Domestic Series 5000 Service Manual

Domestic Series 5000 Hydraulics
10.7. There is a cartridge that slides into the pump
body. See Figure 10.7.
Second
pump gear
Shaft with
pump gear
Bearing
cartridge
Figure 10.7
• The gears operate within, and are located by the
cartridge.
• The cartridge end is partially sealed. Lubrication
channels direct a metered amount of pressur-
ized oil to the bearings and thrust surfaces.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
11.
11.1. The fittings on the end of the steering unit extend
•
•
•
•
•
26
COMPONENT BREAKDOWN: STEERING
UNIT
NOTE: The steering unit is to be replaced as a
unit if it fails. Disassembling it will VOID the
warranty. The steering unit has been disas-
sembled here to illustrate how it works.
NOTE: Individual components of the steering
unit are not available through Cub Cadet.
through the first two sections of the body, into
the third and largest section. They hold all three
sections of the steering unit body together.
See Figure 11.1.
Figure 11.1
O-rings seal the lines to the steering unit.
O-rings also seal the fittings to the end of the
steering unit.
There are two sizes of fitting: 9/16"-18 and 11/
16"-16
If a 9/16"-18 fitting should come loose, tighten it
to a torque of 25 in-lbs. (221 Nm).
If an 11/16"-16 fitting should come loose, tighten
it to a torque of 27 in-lbs (239 Nm).