Cub Cadet Domestic Series 5000 Service Manual page 77

1.14. On Briggs & Stratton / Daihatsu engines, a Z-fit-
ting connects the cable to the pump. An 8mm
wrench will fit the screw on the cable clamp.
See Figure 1.14.
Cable
clamp
Figure 1.14
1.15. On gasoline powered tractors, the choke cable
must also be disconnected. Use an 8mm
wrench to loosen the cable clamps, then unhook
the z-fittings. See Figure 1.15.
Throttle cable
Choke
cable
Figure 1.15
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Z-fitting
Domestic Compact Dash and Steering Pump
1.16. Remove the two phillips head screws that
secure the lower rear corners of the dash panel.
See Figure 1.16.
1.17. Disconnect the dash wiring harness from the
main wiring harness by unplugging the connec-
tor that is near the fuse / relay center.
1.18. Use a 1/2" wrench to remove the two screws
holding the base of the dash panel to the pedes-
tal. See Figure 1.18.
Main harness
1.19. Close the hood.
61
Screw
Figure 1.16
Fuse and relay
center
Screws
Dash
Connector
harness
Figure 1.18