TEC B-880 series User Manual page 137

6. DIAG. TEST OPERATION
6.3.26 Auto Print Head Broken Element Check
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 >
D I A G N O S T I C
Press the [FEED] key.
< 2 >
P A R A M E T E R
Press the [PAUSE] key 28 times.
A U T O H D
Select auto print head broken element
check with the [FEED] key or [RESTART]
key. (See NOTE 1.)
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a
fast forward.
2. A changed data length is stored in memory by pressing the [PAUSE] key.
Power off
S E T
C H K
Press the [FEED] key
and [RESTART] key
at the same time.
1 . 0 A
V
OFF:
O F F
ON:
Press the [PAUSE] key.
Continued on Section 6.3.27
Centronics I/F ACK/BUSY
Timing Selection.
6-50
6.3 PARAMETER SETTING MODE
Auto print head broken
element check is not performed.
Auto print head broken
element check is performed.
EO18-33007