Vlan Add/Edit - ZyXEL Communications ZyWALL USG 50 User Manual

Table 63 Configuration > Network > Interface > VLAN (continued)
LABEL
Object
References
#
Status
Name
Port/VID
IP Address
Mask
Apply
Reset

11.6.2 VLAN Add/Edit

This screen lets you configure IP address assignment, interface bandwidth
parameters, DHCP settings, and connectivity check for each VLAN interface. To
access this screen, click the Add icon at the top of the Add column or click an
Edit icon next to a VLAN interface in the VLAN Summary screen. The following
screen appears.
ZyWALL USG 50 User's Guide
DESCRIPTION
Select an entry and click Object References to open a screen that shows
which settings use the entry. See
example.
This field is a sequential value, and it is not associated with any interface.
This icon is lit when the entry is active and dimmed when the entry is
inactive.
This field displays the name of the interface.
For VLAN interfaces, this field displays
• the Ethernet interface on which the VLAN interface is created
• the VLAN ID
For virtual interfaces, this field is blank.
This field displays the current IP address of the interface. If the IP address is
0.0.0.0, the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address
(STATIC) or dynamically assigned (DHCP). IP addresses are always static
in virtual interfaces.
This field displays the interface's subnet mask in dot decimal notation.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 11 Interfaces
Section 11.3.2 on page 236 for an
255