Chapter 11 Interfaces
Table 53 Relationships Between Different Types of Interfaces (continued)
INTERFACE
PPP interface
virtual interface
(virtual Ethernet
interface)
(virtual VLAN interface)
(virtual bridge
interface)
trunk
* - You cannot set up a PPP interface, virtual Ethernet interface or virtual VLAN interface if the underlying
interface is a member of a bridge. You also cannot add an Ethernet interface or VLAN interface to a
bridge if the member interface has a virtual interface or PPP interface on top of it.
Finding Out More
• See
Section 6.2 on page 90
interfaces, and zones in the ZyWALL.
• See
Section 6.5.4 on page 98
screens.
• See
Section 11.8 on page 272
• See
Section 7.1 on page 111
port role, and zones.
• See
Section 7.2 on page 115
interface.
• See
Chapter 12 on page 277
11.2 Port Role
To access this screen, click Configuration > Network > Interface > Port Role.
Use the Port Role screen to set the ZyWALL's flexible ports as part of the lan1,
lan2 or dmz interfaces. This creates a hardware connection between the physical
ports at the layer-2 (data link, MAC address) level. This provides wire-speed
throughput but no security.
Note the following if you are configuring from a computer connected to a lan1,
lan2 or dmz port and change the port's role:
224
REQUIRED PORT /
INTERFACE
WAN1, WAN2
Ethernet interface*
VLAN interface*
bridge interface
Ethernet interface
Cellular interface
VLAN interface
bridge interface
PPP interface
details on the differences between physical ports,
for related information about the Interface
for background information on interfaces.
for an example of configuring Ethernet interfaces,
for an example of configuring a cellular (3G)
to configure load balancing using trunks.
ZyWALL USG 50 User's Guide