HP ProBook 6455b Maintenance And Service Manual page 127

11. Remove the two slotted Torx T8M2.5×11.0 screws (1) that secure the display assembly to the
base enclosure.
12. Lift the display assembly (2) straight up and remove it.
13. If it is necessary to replace the display bezel or any of the display assembly internal components:
a. Remove the eight rubber screw covers (1). The rubber screw covers are included in the
Rubber Kit, spare part number 613459-001.
b. Remove the eight Phillips PM2.5×6.0 screws (2) that secure the display bezel to the display
assembly.
c. Slide and hold the display release latch (1) to the right.
d. Flex the inside edges of the top edge (2), the left and right sides (3), and the bottom edge
(4) of the display bezel until the bezel disengages from the display enclosure.
Component replacement procedures
119