Special Operation (Epl-6200) - Epson EPL-6200 Service Manual

EPSON EPL-6200/EPL-6200L

1.5.4 Special Operation (EPL-6200)

With EPL-6200, the functions described below are activated by holding the specified
switches down when turning the printer on.
The functions other than Hexadecimal Dump and Photoconductor
Life Reset must not be disclosed to the user.
Table 1-49. Special Operation
Function
Hexadecimal dump "Start/Stop" and power on *
Photoconductor life reset "Start/Stop" + "Information" and power on *
Initializing EEPROM "Start/Stop" + "Job Cancel" + "Information" and power
on*
Initializing the panel setting value "Job Cancel" and power on*
Program ROM update mode "Job Cancel" + "Information" and power on*
CPU reset Press the Information Switch at occurrence of a service
+ Printing of error sheet call error. An error sheet will be printed after warm boot.
Engine program ROM update mode "Start/Stop" + "Job Cancel" and power on*
Note "*1": The Ready LED and Error LED light up simultaneously when the printer
recognizes the function. Then all the LEDs go out once for one second or so.
"*2": When the switches are released, the Ready LED and Error LED light up
simultaneously, and keep lighting during execution of the function.
"*3": Release the switches when only the Ready LED starts flashing. (Other LEDs light
up)
The Ready LED flashes, while the Paper, Toner and Memory LEDs light up.
Upon completion of download, only the Ready LED flashes.
"*4": Release the switches when only the Online LED starts flashing.
During data reception:
During data transfer to engine:
During other processing:
At writing end:
Product Description
Methods of operation
1
1, * 2
1, 2
*
4
Online LED lighting + Data LED flashing
slowly
Online LED lighting + Data LED flashing
+ Paper, Toner or Memory LED lights up
sequentially
Online LED lighting + Data LED flashing
Online LED flashing slowly + Error LED
lighting
Error Related LED Indications
Size of received data is different from the specification:
Error LED flashing + Paper LED lighting
Mechanical Controller is not Flash:
Error LED flashing + Toner LED lighting
Model code of Mechanical Controller is different from that of the file:
Error LED flashing + Memory LED lighting
Some other error:
Error LED flashing
Error that can not be identified:
All LEDs flashing
1, 2
*
3
Control Panel (EPL-6200)
Revision A
46