98
PBX/Centrex Codes on a Flex Button
For one-button access to Centrex or PBX features:
1.
Program Centrex or PBX code into a Station or System Speed Dial
bin, including hook-flash (FLASH key), [ ], and [#] commands (refer
to
"Speed Dial" on page
2.
Program that speed bin onto a flexible button (refer to
Button Programming" on page
PRI Call Pair Assignment
If enabled in admin programming, this feature allows the user to
activate and deactivate the option of having an incoming call terminate
to multiple pre-programmed, user defined locations. This feature
provides the ability to have both the desktop set and an off-net
location, such as a cell phone or SLT, ring simultaneously. Each line is
monitored so that an answer at either phone instrument terminates
ringing of the non-answered line.
This feature is only supported on PRI trunks for the off-net forward
destination. Inbound trunks can be any type of CO trunk.
This feature will not provide for cascaded "find me" applications.
To activate the PRI Call Pair Assignment feature:
1.
Lift handset or press ON/OFF button, then press the FWD button.
2.
Dial one of the following:
[*] = All calls forward
[#] = CO calls forward
3.
Dial the desired speed dial bin for off-net forwarding.
4.
Replace handset; ON/OFF button extinguishes automatically, if
used instead of handset.
To deactivate the PRI Call Pair Assignment feature:
Lift handset or press ON/OFF button, then press the FWD button.
XTS-IP / XTSc-IP Station User Guide
PBX/Centrex Codes on a Flex Button
105).
62).
"Flexible
March 2007