Wan Traffic Meter - Cisco Small Business RV220W Administration Manual

Administering Your Cisco RV220W

WAN Traffic Meter

STEP 2
WAN Traffic Meter
STEP 1
STEP 2
Cisco RV220W Administration Guide
• SysName—This field displays the host name of this router, from the IPv4
LAN (Local Network) page. name for identification of this router. If you want
to edit the SysName, first save your settings and then click the Edit button.
Any unsaved changes will be abandoned. On the IPv4 LAN (Local Network)
page, edit the Host Name, and then save the changes.
Click Save to save your settings, or click Cancel to reload the page with the
current settings.
Use the WAN Traffic Meter page to enable the traffic meter and traffic limits for
the WAN (Internet) interface.
To open this page: In the navigation tree, choose Administration > WAN Traffic
Meter.
In WAN Traffic Meter section, enter the following settings:
• WAN Traffic Meter—Check the Enable box to enable this feature, or
uncheck the box to disable it.
• Traffic Limit Type—If you enabled the traffic meter, choose one of the
following options:
- No Limit—Choose this option if you do not want to enforce limits for WAN
traffic.
- Downloads Only—Choose this option to enforce a limit on traffic coming
to the Cisco RV220W from the Internet.
- Both Directions—Choose this option to enforce a limit on traffic coming
to the Cisco RV220W from the Internet, and traffic going from the Cisco
RV220W to the Internet.
If you configured a Traffic Limit above, enter the following settings:
• Monthly Limit—Enter the maximum amount of traffic (in Megabytes). When
this limit is reached, additional traffic is subject to the actions that you set in
the When Limit Is Reached section.
9
172