Configuring Networking
Configuring the WAN
Cisco RV220W Administration Guide
The networking page allows you to configure networking settings. This chapter
contains the following sections:
•
Configuring the WAN, page 26
•
Configuring the LAN, page 36
•
Configuring Routing, page 50
•
Configuring Dynamic DNS, page 56
•
Configuring IPv6, page 57
Wide area network configuration properties are configurable for both IPv4 and
IPv6 networks. You can enter information about your Internet connection type and
other parameters in these pages.
Configuring the WAN for an IPv4 Network
These instructions are for configuring your RV220W in an IPv4 network. For
instructions on configuring your RV220W for an IPv6 network, see the
"Configuring the WAN for an IPv6 Network" section on page
WAN configuration depends on the type of connection you have to the Internet:
•
DHCP—See
"Configuring a DHCP Connection" on page
•
Static IP—See
•
PPPoE—See
Connection" on page
"Configuring a Static IP Connection" on page
"Configuring a Point-to-Point Protocol over Ethernet
28.
2
33.
27.
28.
26