Rebooting The Cisco Rv220W; Restoring The Factory Defaults - Cisco Small Business RV220W Administration Manual

Administering Your Cisco RV220W

Rebooting the Cisco RV220W

STEP 1
STEP 2
STEP 3
Rebooting the Cisco RV220W

Restoring the Factory Defaults

NOTE
Cisco RV220W Administration Guide
The Current Firmware Version appears at the top of the page.
Click Browse to locate and select the firmware that you downloaded from
Cisco.com.
If you want to abandon your current configuration settings and restore the default
settings during the upgrade process, check Reset all configuration / settings to
factory defaults. Uncheck the box to retain your current configuration settings.
Choose Start Firmware Upgrade. After the new firmware image is validated, the
new image is written to flash, and the router is automatically rebooted with the
new firmware.
After the router reboots and you log in, you can use the Status > System Summary
page to verify that the new firmware is installed. See
Summary, page 196.
Use the Administration > Reboot Router to reboot the router by using the
Configuration Utility.
To open this page: In the navigation tree, choose Administration > Reboot
Router.
Click Reboot to proceed.
Use the Administration > Restore Factory Defaults page if you want to abandon
your current configuration settings and restore the factory default settings for the
Cisco RV220W.
To open this page: In the navigation tree, choose Administration > Restore
Factory Defaults.
Click Default to proceed.
Alternatively, to restore the factory defaults during a firmware upgrade, see
Firmware Upgrade, page 189.
Viewing the System
9
190