User Log In Policies - Cisco Small Business RV220W Administration Manual

Administering Your Cisco RV220W
User Management
STEP 2
STEP 1
Cisco RV220W Administration Guide
• Enter Your Password (available when editing an existing user)—Enter the
existing password.
• Password (available when adding a user) or New Password (available when
editing an existing user—Enter the desired password. When you are, a
message indicates the relative strength of the password.
• Confirm Password—Enter the new password again to confirm it.
Note: If Password Rules are enabled, the new password must meet the
password complexity requirements. If the requirements are not met, an error
message appears after you click the Save button.
• Idle Timeout—Enter the maximum number of minutes that a user can be
idle. When this limit is reached, the user is logged off.
Note: For SSL VPN users, the group Idle Timeout overrides the individual
user setting.
Click Save to save your settings, or click Cancel to reload the page with the
current settings. Click Back to return to the Administration > User Management >
Users page.

User Log in Policies

Use the User Log In Policies page to enable or disable the user's log in privileges
and to deny or allow a login from the WAN interface.
To open this page: From the Administration > User Management > Users page,
select a user then click Log in Policies.
The Username cannot be changed on this page.
Enter the following information:
• Disable Login—Check this box to prevent this user from logging in to the
Configuration Utility, or uncheck this box to allow this user to log in.
• Deny Login from WAN Interface—Check this box to prevent this user from
logging in from a WAN (Internet) interface, or uncheck this box to allow this
user to log in from the WAN. When the box is checked, this user is allowed to
log in only from a device on the LAN.
9
165