Assembly - Weider WEBE05590 User Manual

Assembly

Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts of the weight bench in a cleared
area and remove the packing materials; do not
dispose of the packing materials until assembly
is completed.
¥ Read each assembly step before you begin.
¥ For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
1. Before assembling this product, make sure
you have read and understand the information
in the box above.
Tap two 38mm Square Inner Caps (21) into the
open ends of the stabilizers on each Upright (1).
Attach the Crossbar (3) to the two Uprights (1)
with four M8 x 57mm Bolts (18), four M8 Washers
(16) and four M8 Nylon Locknuts (17). Make sure
the Crossbar (3) and both Uprights (1) are ori-
ented as shown. The decal on the Crossbar
must be facing up and the long bracket on the
weight rests must be on the side shown here.
2. Tap two 30mm Square Inner Caps (22) into the
open ends of the stabilizer on the Front Leg (8).
Attach the Front Leg (8) to the Frame (2) with the
M10 x 19mm Bolt (31).
¥ As you assemble the weight bench, make sure
that all parts are oriented as shown in the
drawings.
THE FOLLOWING TOOLS (NOT INCLUDED)
ARE REQUIRED FOR ASSEMBLY:
¥ Two (2) adjustable wrenches
¥ One (1) phillips screwdriver
¥ One (1) rubber mallet
¥ Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches or a set of ratchet wrenches.
1
16
17
18
16
2
31
22 8
6
Long Bracket
on Weight
1
Rests
1
Decal
17
16
3
17
18
21
21
2
22