Assembly - Weider Pro 230 User Manual

ASSEMBLY

To make assembly easier, carefully read the
following information and instructions:
• Assembly requires two persons.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
1.
To make assembly easier, read the
assembly tips at the top of this page
before you begin.
Locate the Stabilizer (4) that does not have
warning decals.
Attach the Stabilizer (4) to the Front Leg (2)
with two M10 x 63mm Carriage Bolts (18) and
two M10 Locknuts (19). Do not tighten the
Locknuts yet.
2. Attach the the Front Leg (2) to the Frame (1)
with two M10 x 63mm Bolts (16), two M10
Large Washers (27), and two M10 Locknuts
(19). Do not tighten the Locknuts yet.
All manuals and user guides at all-guides.com
6
• The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
2
19
4
2
1
19
19
18
27
16
27
2