Assembly - Weider 2020 W User Manual

ASSEMBLY

To make assembly easier, carefully read the
following assembly tips:
• To hire an authorized service technician to
assemble the weight bench in your home, call
1-800-445-2480.
• Assembly requires two persons.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
1.
To make assembly easier, read the
information above before you begin.
Orient the Crossbar (3) so that the warning
decals are on top. Attach the Crossbar to an
Upright (1) with two M8 x 55mm Bolts (18), two
M8 Washers (16), and two M8 Locknuts (17);
do not tighten the Locknuts yet.
Attach the Crossbar (3) to the other Upright
(1) in the same way.
2. Orient the Stabilizer (13) so that the indented
holes are facing the floor. Attach the Front Leg
(8) to the Stabilizer with two M8 x 42mm
Carriage Bolts (15) and two M8 Locknuts (17);
do not tighten the Locknuts yet.
All manuals and user guides at all-guides.com
6
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• The included grease and the following tools (not
included) may be required for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
1
3
Warning
Decals
2
17
Indents
15
1
18
16
18
17
8
17
13