Building Block Method (Floor-Mounting) Installation (576-Port Example Shown); Figure 4-3 Floor-Mounting Installation: Attaching The Wall-Mounting Bracket - Panasonic DBS 576 Technical Manual

Chapter 4. - Installing Additional Cabinets
Building Block Method (floor-mounting)
Installation (576-port example shown)
Installation
1. Attach wall-mounting brackets on the rear of all cabinets that are to be installed.
Figure 4-3. Floor-Mounting Installation: Attaching the Wall-Mounting Bracket
Note: Base Cabinet
Expansion Cabinet-1 : cabinet installed on middle rack
Expansion Cabinet-2 : cabinet installed on top rack
2. Place Expansion Cabinet-1 on top of the Base cabinet.
3. Attach the joining sections on the front sides of the Base Cabinet and Expansion
4. Attach the 2 Side Joint Plates onto the joining sections on the sides of the Base
5. Attach Expansion Cabinet-2 following steps 2. to 4.
4-4
The direction that the wall-mounting brackets are attached varies according to
the position (bottom, middle or top rack) where the cabinets are installed. Attach
the wall-mounting brackets according to the figures below.
: cabinet installed on bottom rack
Cabinet-1 with 2 screws.
Cabinet and Expansion Cabinet-1 with 8 screws.
DBS 576 (USA), issued 6/2/98
Section 300-Installation
576-13-300