Section 300-Installation
• D-SUB 9-pin to D-SUB 9-pin
Figure 6-8. Connections for D-SUB 9-pin to D-SUB 9-pin cable
Installation
1. Set switch SW1 on the SCC card to the SMDR position (see Table 6-4 for
2. Install the SCC card in one of the optional card slots.
3. Connect the 9-pin D-SUB connector on the RS-232C cable to the CN5
4. Pass the RS-232C cable through the wiring slot in the cabinet, then connect the
576-13-300
•
If your call logging device is equipped with a 9-pin D-SUB RS-232C
connector, make a cable as shown in Figure 6-8. The cable should be less than 50
ft. long.
details).
connector (port 1) on the SCC card.
9-pin or 25-pin D-SUB connector on the other end to the RS-232C connector of
your call logging device.
DBS 576 (USA), issued 6/2/98
Chapter 6. Peripheral Equipment
6-11