Panasonic DBS 576 Technical Manual page 109

Section 300-Installation
5. Use the supplied cable to connect the connector at the bottom right of the
6. Use the supplied cable to connect the connector at the top right of the TSW576
7. Use the supplied cable to connect the connector at the bottom right of the CBL
8. Use the supplied cable to connect the connector at the top right of the CBL card
9. Use the supplied cable to connect the connector at the bottom right of the CBL
10. Use the supplied cable to connect the connector at the top right of the CBL card
11. After the CBL interconnecting cables are installed, the Cabinet ID rotary switch
576-13-300
TSW576 card installed in the OP1 slot in the 1st cabinet to the connector at the
bottom left of the CBL card installed in the CPC slot of the 4rd cabinet.
card installed in the OP1 slot in the 1st cabinet to the connector at the top left of
the CBL card installed in the CPC slot of the 4th cabinet.
card installed in the CPC slot in the 4th cabinet to the connector at the bottom
left of the CBL card installed in the CPC slot of the 5th cabinet.
installed in the CPC slot in the 4th cabinet to the connector at the top left of the
CBL card installed in the CPC slot of the 5th cabinet.
card installed in the CPC slot of the 5th cabinet to the connector at the bottom
left of the CBL card installed in the CPC slot of the 6th cabinet.
installed in the CPC slot of the 5th cabinet to the connector at the top left of the
CBL card installed in the CPC slot of the 6th cabinet.
on the CBL card must be set to determine the cabinet ID. The ID settings are
shown in Figure 4-23 through Figure 4-27. See "Setting ID No. of Additional
Cabinets" on page 4-27 for more information.
DBS 576 (USA), issued 6/2/98
Chapter 4. - Installing Additional Cabinets
4-23