Table of Contents
Advertisement
Troubleshooting
Check
to see the following
before
asking
for a repair.
If the suggested
solution
still cannot
restore
the
DVD
video camera/recorder
to normal,
do not attempt
to repair
it yourself,
but consult
your
dealer.
Power supplies
Battery cannot be
charged.
29
Battery weakens
fast.
31
32
The CHARGE
indicator
on AC adapter/charger
is blinking.
Is the ambient
temperature
too low or too high?
Charge
the battery
at 50 - 86°F (10 - 30°C).
Is the battery
abnormally
hot?
Remove the battery, leave it for a while to cool down, then charge
it.
Is the DC power cord connected
to AC adapter/charger?
Unplug
it.
Has the battery
been unused
for a long time?
Remove
the battery, and then reattach
it.
• If the battery
does not charge
after you try the above four
procedures,
it may be dead: Purchase
a new battery.
Are you using the DVD video
camera/recorder
where
the
temperature
is low?
A fully charged
battery
(DZ-BP14S/DZ-BP07PW/DZ-BP14SW/
DZ-BP7SW)
may be discharged
sooner than usual at low
temperatures.
Keep extra batteries
on hand.
Battery may be dead.
The performance
of battery will deteriorate
if it is used for an
extended
period
of time or frequently:
Purchase
a new battery.
Is the ambient
temperature
too low or too high?
Charge the battery in environment where the temperature
is 50 - 86°F
(10 - 30°0).
The battery
has possibly
discharged
excessively.
Continue
charging:
After a while, the battery
will be charged
to the
specified
voltage,
and the CHARGE
indicator
will light. Then the
battery
charge
will be completed
normally.
Is battery
charged?
Charge
it.
Power t urns off immediately
after being turned on.
Is Power Save set to "On"?
If the powered
DVD video camera/recorder
is left for as long as 5
minutes
without
recording
or playback
with "Power Save: On"
specified,
it will automatically
turn off to save battery
power. To
restart recording
in this case, set the power switch
to "OFF" and
then set it to "HDD",
"DVD" or "SD". You can also specify
"Power
Save: Off" to stop automatic
power off.
Is the DVD video camera/recorder
set to the sleep/restart
status?
If 30 minutes
or more has elapsed
with the DVD video
camera/
recorder
in the sleep/restart
status,
it will automatically
turn off.
Set the power switch
to "OFF", and then power the DVD video
camera/recorder
again.
When
power is turned
on, the LCD screen
will
turn on and off.
The ACCESS/PC
indicator
is blinking,
even though
nothing
is
displayed
on LCD
monitor
screen.
Power goes off
unexpectedly.
29, 30
29
36
45
146
Advertisement
Table of Contents
