Avaya 4600 Series Installation Manual page 102

Restart Scenarios
4. When control is passed to the code in RAM, the following message displays:
Starting...
5. The telephone detects and displays the speed of the Ethernet interface in Mbps, that is, 0,
10, or 100. The message No Ethernet displays until the software determines whether the
interface is 10 Mbps or 100 Mbps.
Note:
The Ethernet speed indicated is the LAN interface speed for both the telephone
Note:
and any attached PC.
6. The software determines whether sufficient IP Address information was downloaded. In this
scenario, it is discovered that sufficient information has not been downloaded. The
following message displays while the DHCP process is invoked:
DHCP: 0 secs
* to program
The number of elapsed seconds is incremented once per second, until DHCP successfully
completes.
7. The following message displays while the TFTP or HTTP process is invoked:
TFTP: n
www.xxx.yyy.zzz
The number increments once per second, until the TFTP or HTTP server responds.
8. The following message displays while the upgrade script is downloaded from the TFTP
server:
46XXUPGRADE.SCR
n KB received
where n is the number of KBs downloaded.
9. The script file is processed. The software determines that the name of the boot code file in
the telephone (BOOTNAME) is the latest version, and the name of the application file in the
telephone is the same as APPNAME.
10. System-specific registration with the Avaya media server is invoked.
11. Upon completion of registration, dial-tone is available on the telephone.
102 4600 Series IP Telephone Installation Guide
HTTP: n uri