Appliance Setup; Remove Shipping Materials; Remove Grate Shipping Support; Clean The Appliance - Heat & Glo SL-550TV-D Owner's Manual

12

Appliance Setup

A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Remove Grate Shipping Support
• Remove the log pack and hood, if applicable.
• Bend top retaining tab of grate shipping support into
vertical position (see Figure 12.1).
• Lift grate slightly upward with one hand so that the grate
clears the support.
• Slide shipping support to side, remove and discard.
• Lower grate onto refractory.
Figure 12.1
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included with
accessories. See Service Parts List for appropriate acces-
sories. Refer to Section 16.
WARNING
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result in
a safety hazard.
• Only Hearth & Home Technologies
approved accessories may be used safely.
Heat & Glo • SL-550 / 750 / 950TV-D • 2053-985 Rev. H • 9/06
E. Install the Refractory
F. Lava Rock, Vermiculite, Rockwool/
Ember Placement
WARNING
Explosion Risk.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• When placing Glowing Embers
should be taken so that the ports are not covered.
Place the dime-size ember pieces about 1/2 inch apart
near port holes in burner top, but not on or in between
the ports. For best performance do NOT place embers
on ports at rear of burner (see Figure 12.2). Failure to
follow this procedure will likely cause lighting and sooting
problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
Figure 12.2 Placement of Embers
®
onto the burner care
25