Table of Contents
Advertisement
4.4
Replacing The Lens
A variety of lenses are available to accommodate different throw distances and specific types of
installations. See page 5-1 for details. To change a lens, follow the steps below.
NOTES: 1) You will need a 9/64"(3mm or 3.5mm) hex socket ball driver (supplied with projec-
tor) or allen wrench for this procedure. 2) "Top" or "bottom" references assume a non-invert-
ed projector, as illustrated. 3) If you are installing a lens, first make sure its Lens Adapter is
present on either the lens or projector. Such an adapter/flange secures to the projector in the
same manner as the flange described below, but accommodates a screw-mount lens.
STEP 1
Turn off the projector, cool, and unplug.
Before removing or installing a lens, turn off the projector and allow it to cool for five minutes
before unplugging. Make sure that the lens cap is on.
!
Unplug the projector.
Install the lens cap.
STEP 2
Loosen the 3 lens mount screws
IF FIXED LENS: Use the hex socket ball driver
provided with the projector to loosen the 3 lens
mount screws that secure the lens flange to the
mount-loosen these screws only, do not remove. See
Figure 4.10.
WARNING
Figure 4.9. Install lens cap
Figure 4.10. Loosen 3 screws
4-5
MAINTENANCE
- FIXED LENS -
Advertisement
Table of Contents
