Runco Reflection VX-5c Owner's Operating Manual page 30

INSTALLATION AND SETUP
l;kjd;flkj;lkasjd;lkjfa;sdff
;laskdjf;lieuiodmca:LKs
eopedjivncfhasp;rpprgm
oiawoedfpawreoifasjdfl
l;kjd;flkj;lkasjd;lkjfa;sdff
;laskdjf;lieuiodmca:LKs
eopedjivncfhasp;rpprgm
oiawoedfpawreoifasjdfl
RS-422
Use either or both
NOTE: Programming for the RS-232 controller
must be compatible with the RS-422 controller
Communication parameters such as baud rate must be set to match the particular controlling
device-refer to the documentation that came with your controlling device in order to determine
the proper baud rate. See 3.7, Adjusting System Parameters and Advanced Controls if you need
help changing the projector baud rate from its default of 38400.
NOTES: 1) To avoid damage, connect only properly wired serial communication cables. See
Appendix D for details. 2) It is recommended that each RS-232 communication cable be no more
than 25 feet in length. Use high quality cables.
Proj 001
RS-232
Figure 2.23. Assorted Networks
l;kjd;flkj;lkasjd;lkjfa;sdff
;laskdjf;lieuiodmca:LKs
eopedjivncfhasp;rpprgm
oiawoedfpawreoifasjdfl
Proj 002
l;kjd;flkj;lkasjd;lkjfa;sdff
;laskdjf;lieuiodmca:LKs
eopedjivncfhasp;rpprgm
oiawoedfpawreoifasjdfl
Use either or both network cable types
2-24
l;kjd;flkj;lkasjd;lkjfa;sdff
;laskdjf;lieuiodmca:LKs
eopedjivncfhasp;rpprgm
oiawoedfpawreoifasjdfl
Proj 003
l;kjd;flkj;lkasjd;lkjfa;sdff
;laskdjf;lieuiodmca:LKs
eopedjivncfhasp;rpprgm
oiawoedfpawreoifasjdfl