Table of Contents
Advertisement
OPERATION
Use CHANGE LAMP to record
the serial number for a newly
installed lamp.
In the Lamp S/N window, use the
number text entry keys to record
the new lamp serial number, and
press
Enter
change. See Using Slidebars and
Other Controls if you need help entering the number. Once entered, the new lamp serial number
will be added to the Lamp History menu and the Lamp Hours timer will reset to "0". Lamp
Mode and Lamp Limit remain as they were for the previous lamp, and can be changed at any
time.
NOTE: Enter a serial number only if you have just installed a new lamp. This will help ensure
that lamp timer is not reset on an old lamp and that the number of hours logged on the lamp
will be accurate.
Service
The Service submenu is also accessed through the Advanced menu, but it is password-protected
and intended for use by qualified service technicians only.
Status
This read-only menu lists a variety of details about the standard and optional components cur-
rently in use on the projector. Refer to the Status menu for versions of hardware (left side) and
software (right side) installed, the number of lamp hours logged in total and for a specific peri-
od (such as a rental period), and for your projector model name and serial number. In addition,
the Status menu identifies the current channel, switcher, slot and frequencies.
Use
ON
again to accept the
Always record the serial number of a NEW lamp.
,
,
or
to see additional Status information.
OFF
Lamp
Lamp Hours
1999
Lamp S/N
1234
⌧
1.
Lamp Message
2.
Lamp Limit
2000
3.
Lamp Mode
Power
4.
Power
700
5.
Intensity
2750
6.
Lamp History
7.
Change Lamp
!
!
IMPORTANT
3-39
Lamp History
New S/N entry
S/N
Hours
automatically updates
Lamp History...
1234 1999
Lamp S/N 5678
5678 0
and resets Lamp Hours to "0"
Advertisement
Table of Contents
