Table of Contents
Advertisement
OPERATION
To use a specific projector, enter the 3-digit number assigned to the projector you want to use.
Press
Enter
are currently using, the checkmark will be deleted.
To broadcast to multiple projectors, press
tor number. Keypad commands will then affect all projectors present.
NOTES: 1) The "Broadcast Keys" option in the Communications menu must be selected for
only one (any) projector in a serial network. The keypad in use must be OFF (disabled) for the
remaining projectors. See 2.10. Keypad Protocols and Conversion, and 3.7, Adjusting System
Parameters and Advanced Controls.
Pixel
Pixel
Press
Pixel
first: use
correct consistency of the image. For proper phase, use
pixel phase so that any shimmer disappears and the image is stable throughout. See 3.6,
Adjusting the Image (Size and Position subsection) for a complete explanation of tracking and
phase.
Position
Position
Press
Position
move the image left or right, use
Shutter (OPTIONAL)
Shutter*
If your projector has a mechanical lens shutter (a.k.a. dowser) installed, press and hold
for approximately 1 second to toggle the shutter closed or open with a single key press (this
also blanks the image electronically). Or quickly press and release
with
ON
present status). Close the shutter whenever you want to mute all display yet maintain access to
projector functions. Open the shutter to regain the display. With no shutter installed,
blanks the image electronically, but the blanking is not quite as black.
NOTES: 1) The status of the shutter is shown in the LCD window on the rear panel of the pro-
jector. 2) Upon power-up, the shutter is open. 3) The lamp remains on.
Mute
Mute*
Use
Mute*
1 second to toggle the audio on or off with a single key press. Or quickly press and release
and follow immediately with
you are unsure of the present status). In either case, a small message appears on screen to signi-
fy mute status.
Function Key
Func
When no menus are on-screen or active, press
specific color or colors in the display. For example,
green data,
shown below and also appears on the back of the IR remote keypad. Color enabling can also be
accessed through the menu system rather than these shortcuts.
to select, press
Exit
to access the pixel tracking and pixel phase double slidebar. Adjust pixel tracking
and
to increase or decrease the frequency of the pixel sampling clock to
to move the image using the double slidebar. At the slidebar, use
or
if you want to guarantee the correct toggle (useful if you are unsure of the
OFF
to mute audio and/or hide the current menu. Press
ON
will display all colors data. The list of available color combinations is
Func
6
7
to cancel. If you switch to a projector other than the one you
and
Proj
Proj
and
to move the image up or down.
ON
OFF
or
if you want to guarantee the correct toggle (useful if
OFF
followed by a 2-digit number to enable a
Func
Func
3-8
then again without entering a projec-
and
to increase or decrease
ON
OFF
and follow immediately
Shutter*
and hold for approximately
Mute*
will display only red and
6
4
and
to
Shutter*
still
Shutter*
Mute*
Advertisement
Table of Contents
